Drawing Editor - Move a Single Dimension Line

(Rev: 01/31/03)

There are two methods of moving a Dimension Line.

Method 1	Method 1 1. Select a drawing from the Drawing List dialog box. 2. Move or close the drawing list dialog box out of your way. 3. Left mouse click on the dimension line you want to move. It will highlight. Click on the dimension again, hold the left mouse button down, and release the button where you want the dimension line to be.
	4. If the dimension line is not where you want it repeat step 2. 5. Once you are done moving the selected item, you MUST right click to un-select the item. 6. Print Preview before printing to ensure the dimension line is correct. 7. If the preview looks correct, pick a different drawing. The system will then ask if you want to save, click yes.
Method 2 Coordinate Space - This option is to establish how the line is located. · Model - This will locate the dimension line based off the work point, usually lower left corner of the plane you are working on. · Paper - This will locate the dimension line based off the Paper size, upper left corner of the page	Method 2 1. Select a drawing from the Drawing List dialog box. 2. Move the drawing list dialog box out of your way. 3. Double Left mouse click on the dimension line you want to move. 4. Highlight the Offset and revise to increase or decrease an offset from a location. 5. You can also revise the X,Y coordinate to move a dimension line to another location. 6. OK out. 7. If the dimension line is not where you want it repeat step 2. 8. Print Preview before printing to ensure the dimension is correct. 9. If the preview looks correct, pick a different drawing. The system will then ask if you want to save, click yes.